Z wave dimmer switch12/16/2023 Put your controller in the EXCLUSION mode and tap the switch quickly 3 times, then try adding it to your network again Tap your Z-Wave switch quicker 4 or 5 times once you put the controller in the inclusion mode to ensure the command has gone through Bring the controller closer to your Z-Wave switch or use a hand-held secondary controller for inclusion If you are unable to include the Z-Wave dimmer to your controller, please try one of the following: A new dimming device should appear on your controller's device list Tap the switch on and off quickly 3 times to finalize the inclusion processĤ. Put your Z-Wave controller in inclusion modeģ. NOTE: All previously recorded activity and custom settings will be erased from the device’s memory.Ģ. This device may not be reset manually when the network’s primary controller is missing or otherwise inoperable. You may use any certified Z-Wave controller to exclude and reset the switch. The switch will be reset to factory defaults only by exclusion using a Z-Wave controller. The device should disappear from your controller's device list Factory reset Z-Wave Dimmer Light Switch Tap the switch on and off quickly 3 times to complete the exclusion processĤ. Put your Z-Wave controller in exclusion modeģ. Bring your Z-Wave gateway hub or controller as close to the switch as possibleĢ. Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code viaġ.Zooz describes Z-Wave Dimmer Light Switch as having the following features: The following security modes are directly supported: As a Z-Wave Plus certified product, Z-Wave Dimmer Light Switch supports Z-Wave S2 security.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |